Mount for a small grinder from a pillow from the engine

Pin
Send
Share
Send

Many devices have been invented to facilitate the holding of a power tool in hands. There are complex designs, there are simpler ones. So we will make one such quite simple for a small grinder - a mount from a pillow from a car engine.

To make this design, you need to take: a "pillow" from the engine of the car, two large corners and one small, large clamp, thick spring, different bolts, washers, nuts, a section of a profile pipe 20 * 20 mm.

First of all, let's drill holes in the profile pipe 20 * 20 mm. Then with the help of angle grinders in two walls of the profile it is necessary to make a longitudinal slot. Then you need to connect a pair of bolts, washers and nuts "pillow" and the profile pipe.

The main stages of work

We attach the resulting part to the base, which can be used as a sheet of plywood (or board), at the corners with screws. We drill holes in the "pillow" for attaching the spring. We bend it under the "pillow" and attach it to a small corner, and it - with screws to plywood.

Now the homemade product is ready, try to test it. We insert a small grinder into the clamp, which was previously threaded through a drilled hole in the profile. Then we fasten it with a bolt with a profile tube. For this, a through hole is prepared at the top. Tighten the clamp and begin to work.

Details on how to make a mount for a small grinder from a pillow from the engine, you can see in the video on the site. Do not forget about safety when working with an angle grinder.

Pin
Send
Share
Send

Watch the video: Replacing Engine Mounts for Volvo S60 - Fix VibrationsShaking C70, S60, S70, S80, V70, XC70, XC90 (November 2024).