DIY hydraulic press from a car jack

Pin
Send
Share
Send

To remove bearings from the shaft, as well as for other metal work, a mini hydraulic press is always useful in a home workshop.

It can be made from a car jack of 3 tons, a building corner and a profile pipe.

The first step is to cut the workpieces from the corner and the profile pipe. It will take two square profiles and six corner sections.

Sliced ​​workpieces will need to be cleaned with a grinder for subsequent painting.

The main stages of work

At the next stage, all six segments from the building corner will need to be painted.

In profile pipes, which will act as racks, it is necessary to drill holes.

You will also need to make a support rail for the jack from a piece of metal strip. At the edges, the author welds two pieces of the channel to it - the width of the racks from the profile pipe.

Two springs are attached to the stop rail so that it quickly returns to its original position.

Putting all the structural elements together. Large corners are bolted to the racks: in the upper part and in the middle. Smaller corners are attached to the bottom of the racks for better stability.

Details on how to independently make a compact hydraulic press from a car jack can be seen in the video.

Pin
Send
Share
Send

Watch the video: How To Make Hydraulic Press Machine. DIY Mini Hydraulic Press. Without Welding (November 2024).